Bamboo poles for photovoltaic support? Don't be greedy for petty gains
Bamboo poles for photovoltaic support? Don't be greedy for petty gains
Let's see its feasibility:
Photovoltaic bracket is a special bracket designed for placing, installing and fixing solar panels in solar photovoltaic power generation systems. The general materials are aluminum alloy, carbon steel and stainless steel. The related products of the solar energy support system are made of carbon steel and stainless steel. The surface of the carbon steel is hot-dip galvanized and will not rust for 30 years in outdoor use. The characteristics of the solar photovoltaic support system are no welding, no drilling, 100% adjustable, and 100% reusable.
The bracket is the structural member that supports the component, and connects the component with its attachments: roof or ground, building components, etc. But to meet the above requirements, we can find that the support must be strong and strong in structure, which can meet the requirements of wind and snow pressure, otherwise it will be difficult to meet the requirements of support. Second, the life span must be long, corrosion resistance, and sufficient Ensure that the support and photovoltaic modules have the same life span. Therefore, some people regard the support as the backbone of a photovoltaic power station.
In this way, using bamboo poles as photovoltaic supports is not the next strategy!
First of all, bamboo poles are relatively poor in pressure resistance and load-bearing. As a support, it must first bear the weight of the battery board and other components and form a stable support for it, but the bamboo pole is obviously not enough.
Second, the ability to resist wind, sand, rain and snow is poor. We all know that due to the characteristics of photovoltaic power plants, they are exposed to the outside, so they must withstand wind, sand, rain and snow, and the reliability of bamboo poles in the face of these severe weather is difficult to guarantee. Once damaged, it is completely possible to cause damage to photovoltaic modules. Damage, greater loss.
Third, the service life is short. Compared with the mainstream brackets on the market today, the service life of bamboo poles seems to be rare. It is really difficult to make it and components have a life span of 25 or even 30 years.
In fact, the importance of the bracket is self-evident, and it is also a topic that goes without saying for the photovoltaic people.
The bamboo pole photovoltaic support in the article, we can only say that it is a special method under special circumstances, and it is not referential and implementable. You must not be so "aggrieved" by photovoltaics because of temporary curiosity and greed for cheap, because that might end up being wronged. I’m crying
