how to install solar mounting racks ?
how to install solar mounting racks ?
Solar energy can work intelligently by itself, without manual operation and care.
Facilitate people's lives. And solar mounting is definitely indispensable for installing solar energy.
Installation of solar stents.
1. The choice of solar mountingn structures material
In some coastal areas with high daily winds, most of the solar stents are made of aluminum alloy stents, because they are thick and strong.
Many Solar mounting projects were installed in many countries
2. the distance between the front and rear pillars
During construction, it is necessary to ensure that the front pillars and rear pillars of the steel piles are on the same straight line, and the straight line formed by the front and rear pillars should be perpendicular to the two straight lines formed by the front pillar and the rear pillar. In addition, the straight line should not be bent, and the bending amount should be within 2mm.
The height of steel piles also has corresponding requirements, and the height of the top end of the pile must be at the same level. The distance between the adjacent foundation centers of the front and rear pillars of the steel pile is about 3 meters, and the distance between the front pillar and the rear pillar is about 2 meters.
3. the determination of the position of the longitudinal beam
The center of the welded plate on the upper edge of the front pillar must be at the same level, and the front pillar can be fixed after reserving the corresponding length in the steel pile. Determine the approximate installation angle according to the inclination required by the drawing, and at the same time ensure that the center of the welding plate on the upper edge of the rear pillar is consistent in height, and the rear pillar can be fixed after the length of the steel pile is reserved. After the front and rear pillars are fixed, the step of installing the longitudinal beams on the connecting plate is very important. The center line of the longitudinal beam must coincide with the center line of the front and rear pillars. Next is the installation of the diagonal brace: one end of the diagonal brace is connected to the longitudinal beam, and the other end is connected to the pillar with a hoop. The position of the longitudinal beam must be parallel to each other.
4, assembly
The installation of the solar Mounting structure is not difficult, and the components must be assembled according to the instructions or design drawings during installation. Use a wrench to tighten the screws properly. Remember to put the step of pulling the brace after installation.
5. the choice of direction
Solar stents are generally installed on the roof or the ground at an angle of 5-10 degrees, because this direction is conducive to unobstructed sunlight and can also increase the sunshine time.